Motorhome Accessories
You are here: Home > Standard towbars

Standard towbars

For all motorhomes without frame extension

If you have any general questions, contact us.



Standard towbars

These versions can be used as a standard coupling for all motorhomes without a frame extension or for non-load-bearing frame extensions. The attachment elements for carrier systems to the coupling can be retrofitted at any time without problem.


The D-value is an indication of the strength of a towbar. It can be calculated using the following formula:


D = G(K) x G(A) x 9.81
     G(K) + (A)


Where G(K) is the gross weight of the towing vehicle in tonnes and G(A) is the gross weight of the trailer, also in tonnes. For example, a Fiat Ducato with 3.5t gross weight and towing capacity of 2t requires a towbar with a minimum D value of:


D = 3.5 x 2.0 x 9.81 = 12.50 kN
    3.5 + 2.0


The actual permissible trailer load is based on the value stated in section 28 or 01 of the vehicle registration documents. Of all the given values it is always the lowest value that should be adhered to.


The X dimension specifies the overhang of the mobile home body over the series chassis.

When ordering, please specify the dimensions entered on the drawing if your vehicle should not be listed in
our database. (contact us in case of doubt)

If a tank, storage compartment or similar is installed in your vehicle in the area labelled with “Z”, please request a special dimension sheet by telephone.